Follow Us x
Think of your heating and cooling system as a car. Your car needs oil changes, brake pads, and tune-ups on a regular basis in order for it to run its best and to avoid some of the expensive repairs that can happen when you don't. Your HVAC equipment is the same way. You want to ensure that your equipment is running at its best. This requires regular cleanings and an experienced technician to go through the equipment to spot any potential problems.
The great thing about a bi-annual preventive maintenance plan is that it allows you to not have to worry. You pay for the plan up front each year, then you get a call, text, or email to remind you that it is time for the maintenance. Our preventive maintenance package helps extend the life of your furnace, air conditioner, or heat pump, and stave off costly repairs while keeping energy bills as low as possible.
Contact us here at (615) 90-TNAIR and ask to speak to the service department about our maintenance agreements.
Our fall service will include our furnace/heater 20 point tune up.
Our fall service will include our furnace/heater 20 point tune up.
It includes:
- Inspect/Adjust thermostat
- Inspect heat exchanger for cracks/rust
- Lubricate any motors, if necessary
- Inspect blower motor, blower wheel, and capacitor
- Replace filters with customer-provided filters or replace filters with our filters for $15.00 each
- Clean/Adjust Burner Assembly
- Inspect/Test Safety Controls
- Measure Heat Rise to prevent overheating heat exchanger
- Test for carbon monoxide
- Check/Adjust gas pressure
- Inspect gas piping for gas leaks
- Inspect exhaust venting system
- Inspect Ignition Assembly
- Inspect Heating Elements Inspect Flame Sensor
- Clean condensate drain/pump
- Measure Amp Draws
- Inspect/Tighten electrical connections
- Inspect ductwork
- Perform Sequence of Operations
Our Spring Service will include our Air Conditioning 30 Point Tune Up.
Our Spring Service will include our Air Conditioning 30 Point Tune Up.
It includes:
- Inspect thermostat
- Check refrigerant pressures, if necessary
- Inspect /Tighten all electrical connections
- Inspect and obtain readings of all start and run capacitors
- Inspect Safety Controls
- Inspect Evaporator Coil
- Inspect/Clean condenser coil
- Clean out condensate drain/pump
- Test Condensate Kill Switch Inspect outdoor fan motor/blade
- Inspect indoor blower motor, blower wheel, and capacitor
- Lubricate all motors that require it
- Measure temperature difference across indoor coil
- Inspect ductwork for leaks, damage, and determine if sized correctly
- Inspect Contactor/Measure voltage drop.
- Replace filters with customer-provided filters or replace filters with our filters for $15.00 each
- Measure Amp Draws
- Measure temperature drop across dryer
- Perform Sequence of Operations
Please see additional plan benefits and terms and conditions.
